Big Game Hunting > Muzzleloader Hunting
Knight Bighorn rail for scope??
duckmen1:
--- Quote from: Irishbackwoods on June 26, 2024, 06:51:17 PM ---https://www.murphyprecision.com/knight-muzzle-loader-older-straight-pull/
$$$ but they are very nice, machined once they get your order, and you can do stainless steel or titanium. High quality
--- End quote ---
I wish I would have seen this option when I was setting up the leupold red dot on my knight. Looks like a great setup. I do like my setup but this would have taken a lot of guess work out of scope rings and such.
JWBINX:
Just try a couple Weaver # 15 (48015).
They will be two piece bases that work fine.
They will probably be under 20.00.
Take your rifle with you to check hole spacing and contour.
bustedoldman:
Remington 541 Pattern bases work as well.
https://www.muzzleloaders.com/product-category/muzzleloader-scopes-optics/scope-bases-rings/
huntnphool:
I put the Murphy on mine, works great with the Seekins Rings and RDS. :twocents:
Chukarhead:
Good leads above from the hive mind. I wanted to mount a Leupold Freedom RDS with Warne QD rings to ease cleaning. I started with Warne two-piece mounts, but the spacing of the rings on the RDS wouldn't allow it to drop into the slots. Boo. I eventually bought a 0 degree rail from EGW (https://egwguns.com/knight-bolt-action-muzzleloader-picatinny-rail-0-moa), and had it chopped in two and coated by the Cerakote King of Tacoma. Without chopping, it's *tough* to access the Red Hot nipple I'm running. I'm happy with the results, but might have gone a different direction if I had it all to do over.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version