Big Game Hunting > Muzzleloader Hunting

POI Shift Troubleshooting **UPDATE, SOLVED IT***

<< < (2/2)

raydog:
When you put the adapter on for the spartan bipod, is it possible the screw is just a little longer than it should be, possibly coming close or contacting the barrel?

Hope you figure it out, that's always frustrating

adamR:

--- Quote from: raydog on September 24, 2024, 12:53:25 PM ---When you put the adapter on for the spartan bipod, is it possible the screw is just a little longer than it should be, possibly coming close or contacting the barrel?

Hope you figure it out, that's always frustrating

--- End quote ---

It's hard to say. But, to rule it out, I just ripped the adapter off and put the sling stud back on. I don't have a ton of time to rule things out so a change like that was easy.

raydog:

--- Quote from: adamR on September 24, 2024, 03:38:57 PM ---
--- Quote from: raydog on September 24, 2024, 12:53:25 PM ---When you put the adapter on for the spartan bipod, is it possible the screw is just a little longer than it should be, possibly coming close or contacting the barrel?

Hope you figure it out, that's always frustrating

--- End quote ---

It's hard to say. But, to rule it out, I just ripped the adapter off and put the sling stud back on. I don't have a ton of time to rule things out so a change like that was easy.

--- End quote ---

Good luck, and keep us posted

adamR:
For anyone interested, the powder issue solved it. I measured out 81.8 grains of powder by weight, which again was far less by volume than the other powder. I was shooting even better than before. My last two shots, I dialed for 175 and 200 with the Leupold Freedom RDS BDC and had a three inch group at my POA.

Lesson learned and I will no longer measure by volume in the future.

Navigation

[0] Message Index

[*] Previous page