Equipment & Gear > Guns and Ammo
suppressor for a 7mm-08
pickardjw:
I'd be looking at the following:
TBAC Ultra 7 (the standard by which others are measured)
Dead Air Nomad Ti XC or Nomad-30
AB A-10 (budget friendly)
Otter Creek Hydrogen S
CGS Hyperion K
Unknown Suppressors Reaper
Airlock Zero Gravity 7mm
As others have mentioned, the problem with the Scythe is weld failures. There's some good info on this issue in the thread linked below. A few of the above are 3D printed titanium, which significantly reduced that potential failure.
https://rokslide.com/forums/threads/silencerco-scythe-ti-failures.386687/
elkboy:
Thanks, all! I appreciate the input.
Dreadi, might follow up with you if that's OK. Just need to note I'm an Oregon resident now, if that makes a difference.
dreadi:
--- Quote from: elkboy on November 10, 2025, 03:53:29 PM ---Thanks, all! I appreciate the input.
Dreadi, might follow up with you if that's OK. Just need to note I'm an Oregon resident now, if that makes a difference.
--- End quote ---
Works for me. I can ship to a transferring dealer anywhere.
Black Hammer Arms
www.blackhammerarms.com
The Guy On HuntWA Selling Suppressors
@blackhammerarms
Antlershed:
I have a TBAC Ultra 9 on an 18” 6.5 CM and a Magnus on a 24” 6.5 PRC. Both provide great noise/recoil reduction. With the Magnus on the PRC you can hear the bullet impact the animal.
dreadi:
--- Quote from: Antlershed on November 11, 2025, 08:43:57 AM ---I have a TBAC Ultra 9 on an 18” 6.5 CM and a Magnus on a 24” 6.5 PRC. Both provide great noise/recoil reduction. With the Magnus on the PRC you can hear the bullet impact the animal.
--- End quote ---
This is the way.
Black Hammer Arms
www.blackhammerarms.com
The Guy On HuntWA Selling Suppressors
@blackhammerarms
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version