Hunting Washington Forum

Equipment & Gear => Guns and Ammo => Topic started by: sticky on August 16, 2012, 10:38:26 AM

Advertise Here

Title: New Pelican case for my new X-bolt
Post by: sticky on August 16, 2012, 10:38:26 AM

I picked up a Pelican 1750 dbl rifle case when I bought my X-bolt 06 a few weeks ago.  Pelican makes one solid case.  I understood their cost when I saw one up close.  A couple days ago, I finally traced and cut out the foam for the gun, bolt, mag, and rangefinder.  I used an electric knife and it worked ok until I screwed up the barrel section a little.  I wished I had used a sharp knife on the barrel like I did with the bolt.  Anyway, here are some pics.

Title: Re: New Pelican case for my new X-bolt
Post by: xXLojackXx on August 16, 2012, 10:47:42 AM

Love my pelican cases too. I would just flip that foam around so the gun isn't upside down when carrying it. But I might just be OCD haha

Title: Re: New Pelican case for my new X-bolt
Post by: sticky on August 16, 2012, 07:53:53 PM

I thought about that, but I wanted most of the weight down by the wheels and the serial # facing up.