Hunting Washington Forum

Equipment & Gear => Guns and Ammo => Topic started by: 270Flat on October 10, 2012, 09:07:44 AM

Title: Shotgun help
Post by: 270Flat on October 10, 2012, 09:07:44 AM: My Remington 1100 only partially ejects the low brass shells (2 3/4") I am target shooting with. I first thought it might be a compression issue. Put in a new seal ring, but still the same result...

My season ended well last year, killing a limit of ducks with out issue. Cleaned it up and put it away until this last target shoot.

Suggestions?
Title: Re: Shotgun help
Post by: Huntbear on October 10, 2012, 09:10:24 AM: Gas port holes are partially plugged up with crud... would be my first guess. Will heavier shells run through it fine?
Title: Re: Shotgun help
Post by: quadrafire on October 10, 2012, 09:12:05 AM: I would break it down and cleand the piston rings and the tube they slide. That is an area that could get kind of sticky :dunno:
Title: Re: Shotgun help
Post by: 270Flat on October 10, 2012, 09:28:20 AM: I was shooting 3" steel to end my season last year. I will try something like that today. I will also clean the slide to rings. Thanks!!