Hunting Washington Forum
Community => Butchering, Cooking, Recipes => Topic started by: wiremonkey on April 13, 2014, 12:04:26 PM
-
Not all meat requires smoke through the whole cooking process, so I am wondering do you apply smoke at the beginning or at the end. Thanks for any help. :)
-
I did it at the end. I used to put the meat in the oven all wrapped up and set the temp to slowly get the interior above the safe level for a bit. Then would go fire up the smoke so it was ready by the time the meat would come out. I was under the impression that the smoke was cooler than the temp in the oven so it would smoke the meat while it was slowly resting. It would be cooled down to eating temp by the time the smoke was done.
-
Typically you are better off adding the smoke first and then finishing in the oven. When the water activity of the meat being smoked is higher it allows the smoke constituents to be more readily absorbed into the meat vs. when the meat is dryer and you basically get a surface application of smoke. Try it both ways and you will see the difference. It is not as readily apparent on say a large roast or cut of meat, but if you are doing jerky, smoked salmon, or have already created a good "skin" on your product the smoke does not penetrate and just lays a coat on the surface, if you try to smoke it too much like that it will actually tar the surface. That is why it is better to lay down the level of smoke you want and then finish to proper temp. In certain circumstances it can also create unsafe food products by holding them at unsafe temps for extended periods of time.
