Hunting Washington Forum

Equipment & Gear => Guns and Ammo => Topic started by: Rob on March 12, 2020, 06:21:03 AM

Advertise Here

Title: AK Build question for those who have done this
Post by: Rob on March 12, 2020, 06:21:03 AM

question answered!

Title: Re: AK Build question for those who have done this
Post by: hunter399 on March 12, 2020, 06:48:56 AM

I'm almost sure something warped a little when metal got heated from welding.But how to correct it  :dunno:
Cause I don't have any experience building one.But you can always hit it with a hammer till it goes.
There was a YouTube channel called
The ammo channel .That had a ak build .
I will see if I can find a link and post it for ya.

Title: Re: AK Build question for those who have done this
Post by: Rob on March 12, 2020, 06:55:43 AM

Thanks!

Does no look warped - they physically stick out and block the mag in the mag well - I have another set of rails and they are identical.



I'll check out that video.

Title: Re: AK Build question for those who have done this
Post by: hunter399 on March 12, 2020, 06:59:30 AM

Never mind I just looked .youtube deleted about 5 of the videos that the guy had on building it.That sucks cause the guy had all the videos on how to build it and YouTube deleted it .The main reason the guy doesn't post any more videos I guess.

Just Google search ak build and there is some more vids on it.

Title: Re: AK Build question for those who have done this
Post by: NitRally on March 12, 2020, 11:05:21 AM

Checkout mel64d on youtube.

Title: Re: AK Build question for those who have done this
Post by: Rob on March 12, 2020, 01:06:29 PM

Both him and "baby face" have helpful info.

Title: Re: AK Build question for those who have done this
Post by: Rob on March 18, 2020, 06:18:12 AM

Question asked was:  after welding rails into an AK receiver, the lower rails block the magazine from snapping in.  Solution is to remove the lower rails.