Post by: CascadeCruiser on September 26, 2021, 08:39:51 PM
Post by: dilleytech on September 27, 2021, 07:54:03 PM
Post by: Tracker0721 on September 27, 2021, 10:37:45 PM
For your question though, are you using single bevel or double bevel heads? And are you only pushing the head across your stone? If you go back and forth you’ll roll that edge. I learned to sharpen by always “cutting the stone” and eventually you’ll develop that burr which is what you want. Then you sharpen pushing that burr side to side until you strop it and that’s when you change to a pulling motion and you go until the burr breaks off on a microscopic level. There’s great YouTube videos on it. I used to sharpen knives and broadheads for cash once I got it down. Now I use a worksharp and that does a great job, much faster too but still the basics. Consistent angle, pressure and technique.
Post by: CascadeCruiser on September 28, 2021, 05:08:53 AM
Practice makes perfect! “Factory sharp” heads are never near as sharp as a good polished and stropped edge nor are they as strong but different strokes for different folks. They get the job done.
For your question though, are you using single bevel or double bevel heads? And are you only pushing the head across your stone? If you go back and forth you’ll roll that edge. I learned to sharpen by always “cutting the stone” and eventually you’ll develop that burr which is what you want. Then you sharpen pushing that burr side to side until you strop it and that’s when you change to a pulling motion and you go until the burr breaks off on a microscopic level. There’s great YouTube videos on it. I used to sharpen knives and broadheads for cash once I got it down. Now I use a worksharp and that does a great job, much faster too but still the basics. Consistent angle, pressure and technique.
Thanks for the reply. I ended up getting a Norton combo stone with silica carbide. Took 10hrs to get all 6 done but they are polished and sharp as hell now. I think I was starting with too high of a grit with wasn’t getting that initial burr. Now I just need to get on some elk.
Post by: Dysfunctional Vet on September 28, 2021, 05:59:50 AM
Post by: trophyhunt on September 28, 2021, 07:08:00 AM
Post by: CascadeCruiser on September 28, 2021, 07:25:26 AM
I wonder if there is a reason they are not razor sharp? I've always wondered why my shuttle "T"s weren't razor sharp, but they are devastating without doing any sharpening on them, always wondered if they are designed that way. They make a huge hole.
Well in this case they weren’t sharp because I spent hours upon hours tuning my broadheads and shooting into a block and pit. So they were pretty dull after that. Now they are good. Trying to post a video. I was tempted to take them to someone better than I but I managed.
Post by: Jingles on October 03, 2021, 08:10:16 AM
Anyone do it if so care to explain process? I have some Savora BH's and although they do shave hair and killed the bear, but thinking with a little time and effort could be better. Or is this one of those times where you say if it ain't broke don't fix it?