Hunting Washington Forum
Equipment & Gear => Guns and Ammo => Topic started by: jeepster on August 22, 2010, 12:35:51 PM
-
anybody familiar with the stevens/savage 58 in 410? ive been after a magazine for it for years... i figure if i go to enough gunshows, and ask enough people, one might appear...
does anybody know if it is possible to cross refference parts- meaning if they used the same parts on different guns?
ive seen some in internetland for the 58b and whatnot, but no mags secifically for 2 1/2 inch shells...
ive tried most of the gun parts sites and have been watching gunbroker and what not
-
go here for 410 mag.
http://www.gunpartscorp.com/catalog/Products.aspx?catid=709 (http://www.gunpartscorp.com/catalog/Products.aspx?catid=709)
AWS
-
AWS,
appreciate it, but what is making this a dificult mag to find is that the gun is only chambered in 2 1/2, and all the clips out there are for 2 3/4+ ive spend most of the morning searching the internet for one......
-
Try calling savage.
(413) 568-7001 for parts and service (please have your serial number and credit card available)
I bet they can at least point you in the right direction.
-
savage said to go to numrich, numrich only has a mag for 2 3/4 & 3 inch which doesnt sound right... the worst part is that i was on hold for 10 minutes only to get told by some lady in a super nasaly new york accent(worst sound in the world) that she doesnt know anything about guns and to hold on while i get transfered.... so i hung up.
im going on a trip down the coast, ill just stop at every gunshop i see from here to san diego. probability says i should find something.....