Hunting Washington Forum
Equipment & Gear => Guns and Ammo => Topic started by: JohnVH on May 16, 2019, 11:34:18 AM
-
Anyone have a recommended place to thread a few barrels? I really dont want to ship them off to get done if I dont have to. Prefer a place as far north as possible in WA, but Ill drive some if I have to.
Thanks
-
Might be able to get benchmark barrels to do it for you depending on how busy they are. Give them a try.
-
Anyone have a recommended place to thread a few barrels? I really dont want to ship them off to get done if I dont have to. Prefer a place as far north as possible in WA, but Ill drive some if I have to.
Thanks
When you say as far north as possible, do you mean west or east side north?
-
Location would be helpful
-
Sorry guys, as close to Bellingham/Lynden area.
-
Might be able to get benchmark barrels to do it for you depending on how busy they are. Give them a try.
:yeah:
Benchmark is in Arlington just off I-5 exit 208 give them a call.
Telephone: 360-652-2594
-
Same question here but for Olympia area to around Longview.
-
Benchmark can be pretty quick. The small cost of shipping it to them would be worth the peace of mind knowing it gets done right. Worth a phone call to see how busy they are.
-
Benchmark looks to be an hour drive, Ill probably just bring a few there to get done. Unless I can find someone closer.
-
Where is your D.I.Y. spirit? How bad could it possibly be... :dunno:
-
It's a lot more south, but Firemasters in Cinebar does some good threading work for suppressors and breaks.
-
It's a lot more south, but Firemasters in Cinebar does some good threading work for suppressors and breaks.
thank you.
-
I just sent a barrel to Bison Gun Works. He charged me $150 to thread for a Savage small shank, chamber for a 338/375 Ruger and thread the muzzle 5/8"x 24. there is also a $20 return shipping charge. Had my barrel back in 9 days.
He did a very good job.
-
I just sent a barrel to Bison Gun Works. He charged me $150 to thread for a Savage small shank, chamber for a 338/375 Ruger and thread the muzzle 5/8"x 24. there is also a $20 return shipping charge. Had my barrel back in 9 days.
He did a very good job.
looking forward to your results with this!
-
I brought two barrels to Benchmark on Friday. They said 2-3 week wait. They've been very busy lately.
-
Any local gunsmith should be able to thread a barrel.......just sayin'.
-
Any local gunsmith should be able to thread a barrel.......just sayin'.
I tried. Just sayin.. The only one that could. Charged over $200