Post by: Beardo on May 22, 2013, 10:39:57 AM
Any advise?
Post by: BULLBLASTER on May 22, 2013, 02:07:45 PM
Just installed a new trophy taker smackdown pro fc on my bow and have a quick question. I installed it and got the cord adjusted, then I paper tuned it. It's shooting bullet holes now. I noticed when doing my walk back tuning that the launcher arm is not raising to the full upright position. Before I take the time to adjust my sights I wanna make sure I won't have to change something again. My arrow at full draw looks parallel and its set slightly above the berger hole??? I think that's what it's called haha.Does the launcher go up as far as it can? On the newer smackdowna the launcher stops before hitting vertical. Just loosen the cable and.see if the launcher gore's to the same spot as when you draw. If it goes all the way its good.
Any advise?
Post by: Beardo on May 22, 2013, 11:05:49 PM
Post by: Beardo on May 23, 2013, 06:23:43 AM
problem solved haha. Probably should have done that first........thanks.Just installed a new trophy taker smackdown pro fc on my bow and have a quick question. I installed it and got the cord adjusted, then I paper tuned it. It's shooting bullet holes now. I noticed when doing my walk back tuning that the launcher arm is not raising to the full upright position. Before I take the time to adjust my sights I wanna make sure I won't have to change something again. My arrow at full draw looks parallel and its set slightly above the berger hole??? I think that's what it's called haha.Does the launcher go up as far as it can? On the newer smackdowna the launcher stops before hitting vertical. Just loosen the cable and.see if the launcher gore's to the same spot as when you draw. If it goes all the way its good.
OAny advise?