Hunting Washington Forum
Equipment & Gear => Guns and Ammo => Topic started by: xXLojackXx on February 24, 2015, 07:29:00 PM
-
Anybody shooting a 7 Dakota on here. Having Benchmark build me another rifle and that's the caliber this time. Would like to see some rigs and discuss some data if so.
-L
-
are you getting a rate of twist to shoo the 180+'s?
-
Build specs as follows:
-Defiance Deviant Hunter action
-Shillen trigger
-McMillan A3 GAP molded camo
-HS Precision DBM
-Benchmark #6 Kreiger contour 1:9 twist @ 27" fluted w/ slim muscle brake
-Devcon Ti bed
-Seekins 34mm rings
-Steiner T5Xi scope
-
Somebody besides Deadlift has to be shooting a 7 Dakota on here :dunno:
-
Go with a 28 Nosler
-
Go with a 28 Nosler
You mean a copy of the 7 Dakota...?
-
Go with a 28 Nosler
You mean a copy of the 7 Dakota...?
:tup:
-
Go with a 28 Nosler
Not sure if I would go that route, no brass yet or much load data. Its a interesting case but it does the same thing every other big 7mm will do. There are no free lunches either, that much case and powder means high temps and erosion. You could load it down, but then why not get a 7mm rem mag. My Dakota eats 77.6 grains of retumbo and pushes the 190 matrix at 3066. Personally I seen no reason to shoot any pill smaller than the 180, it's just no fun :IBCOOL:
Chris
Benchmark
-
Yes I had a 7 Dakota built a couple years ago. Absolutely love that gun. Since then my dad and a buddy have had one built. Shooting the 168's.