Hunting Washington Forum

Equipment & Gear => Power Equipment & RV => Topic started by: Boss .300 winmag on June 20, 2016, 02:41:02 PM

Title: TRUCK SUSPENSION PART.
Post by: Boss .300 winmag on June 20, 2016, 02:41:02 PM: Can this vertical linkage be changed without a front end alignment being done? It's the one center picture. It's sheared at the bottom.
Title: Re: TRUCK SUSPEBSION PART.
Post by: 92xj on June 20, 2016, 02:44:49 PM: Yes, it's a sway bar end link.
Unbolt or cut off old one, replace with new one. Pay attention to the washer bushing order. No alignment needed. Nothing to do with steering for the most part. it helps body roll and handling.
Title: Re: TRUCK SUSPEBSION PART.
Post by: Zardoz on June 20, 2016, 02:49:04 PM: :yeah:
Title: Re: TRUCK SUSPEBSION PART.
Post by: Boss .300 winmag on June 20, 2016, 03:19:28 PM: Ok thanks guys. :tup:
Title: Re: TRUCK SUSPEBSION PART.
Post by: Fastass350 on June 20, 2016, 07:36:30 PM: :yeah:
Looks like a dodge? If you use Amazon they are readily available, just put a couple on my 04 Dodge easy change.
Title: Re: TRUCK SUSPENSION PART.
Post by: Boss .300 winmag on June 20, 2016, 09:43:00 PM: It is a dodge, got the part at the local parts store for $63.00, going to change it out tomorrow. The new one looks heavier duty than the old one. :tup:
Title: Re: TRUCK SUSPENSION PART.
Post by: Boss .300 winmag on June 21, 2016, 01:05:00 PM: All swapped out, popping noise gone, and it steers better. :tup:

Thanks for the info again guys. :4w: