Hunting Washington Forum

Equipment & Gear => Guns and Ammo => Topic started by: 7mm ed on January 15, 2018, 12:26:16 PM


Advertise Here
Title: ruger 3 screw 357 mag
Post by: 7mm ed on January 15, 2018, 12:26:16 PM
i found old ruger three screw for 350 . it has holster wear and a few sratches . dose not have the transfer bar kit in it . is this a good deal on it ?
Title: Re: ruger 3 screw 357 mag
Post by: Encore 280 on January 15, 2018, 12:51:59 PM
You got screwed big time!!! :chuckle: :chuckle: I think you done really good! :tup: Check with Mudflat Mike. Go online and find out when it was made. I have one that was shipped from the factory in '57 and another that was shipped in the '70s, can't remember what year.
Title: Re: ruger 3 screw 357 mag
Post by: Encore 280 on January 15, 2018, 12:58:46 PM
What barrel length? You can shoot 38spec. through it and if you have the convertible with the cylinder then 9mm also.
Title: Re: ruger 3 screw 357 mag
Post by: 7mm ed on January 17, 2018, 04:03:13 AM
I bought the ruger got it for 300.00 and went on the web sight it was made in 1967 it has a 6 1/2 inch barrel .
SimplePortal 2.3.7 © 2008-2025, SimplePortal