Hunting Washington Forum

Equipment & Gear => Power Equipment & RV => Topic started by: elksnout on April 19, 2018, 12:26:27 PM

Advertise Here

Title: 2014 F150 Fuel Filter Replacement
Post by: elksnout on April 19, 2018, 12:26:27 PM

Where would I look to relieve the fuel pressure prior to replacing the fuel filter? I have the 5.0.

Thanks
Elksnout

Title: Re: 2014 F150 Fuel Filter Replacement
Post by: Woodchuck on April 19, 2018, 12:29:29 PM

Fuel System Pressure Release

Pressure release

 1. With the vehicle in NEUTRAL, position it on a hoist.
    Refer to: Jacking and Lifting - Overview See: Vehicle Lifting > Procedures > Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).


 2. NOTE: The Fuel Pump Control Module is located on the frame rail above the fuel tank.

    Disconnect the Fuel Pump Control Module electrical connector.
 3. Start the engine and allow it to idle until it stalls.


 4. After the engine stalls, crank the engine for approximately 5 seconds to make sure the fuel rail pressure has been released.


 5. Turn the ignition switch to the OFF position.


 6. When the fuel system service is complete, reconnect the Fuel Pump Control Module electrical connector.

Title: Re: 2014 F150 Fuel Filter Replacement
Post by: elksnout on April 19, 2018, 09:04:31 PM

Thanks Woodchuck.    :tup:

Elksnout