Hunting Washington Forum
Equipment & Gear => Guns and Ammo => Topic started by: NOCK NOCK on June 07, 2020, 07:23:52 PM
-
Any suggestions? Needs to be rear rail mount I believe....so it will work with a Blackhawk CQC holster.
-
If I was going to mount a sight on a pistol it would either be a Trijicon RMR Type 2, or Leupold Deltapoint Pro.
I have to be honest, I don't see a benefit of a halo sight on a pistol, unless you are shooting competition.
It is totally a personal preference, I prefer iron rights, with TruGlow, or other night sight.
-
Never used one, but have always wanted one. May be a waste of money, but sounds like fun. :dunno:
-
Not sure about mounting a red dot on a 92/96 series but they do make guide rods for those that are internal lasers you may look into that , then no worries when it comes to a holster .
-
Never used one, but have always wanted one. May be a waste of money, but sounds like fun. :dunno:
If you like it, it can't be a waste of money :tup:
-
Not sure about mounting a red dot on a 92/96 series but they do make guide rods for those that are internal lasers you may look into that , then no worries when it comes to a holster .
Im not a big gun nut.....don't know what that is, guessing the pin/rod that is below the barrel that holds the spring? :dunno:
-
You should be able to find some Red Dot mounts for your Beretta. I'm running Red Dots on my SIG 320, Ruger 22/45, Ruger 95, S&W 929 and Remington 597 and Walther .22 AR clone. Old eyes I need them.
Check this one out, looks like it's co-witnessed
https://www.sight-mount.com/ (https://www.sight-mount.com/)
-
Not sure about mounting a red dot on a 92/96 series but they do make guide rods for those that are internal lasers you may look into that , then no worries when it comes to a holster .
Im not a big gun nut.....don't know what that is, guessing the pin/rod that is below the barrel that holds the spring? :dunno:
Exactly!
Here is an example
https://www.lasermax.com/lms-1441g.html