Hunting Washington Forum

Equipment & Gear => Power Equipment & RV => Topic started by: Angry Perch on June 18, 2020, 08:38:08 AM

Advertise Here

Title: Need boat tower fabrication
Post by: Angry Perch on June 18, 2020, 08:38:08 AM

I've got a 21' Hewescraft with a Whodat tower. I need to hinge the tower to fit it in my shop. I'd prefer not to make 2 trips to Centralia to have it done at Whodat. Anyone know of any fabricators in the Seattle Eastside area, or between here and Sequim/ Port Angeles?
Thanks

Title: Re: Need boat tower fabrication
Post by: chukar hunter on June 18, 2020, 08:55:32 AM

Check out Rod Dog Arches in Anacortes.  He just fab'd a tower on my 24' Hewes and did a bunch of custom work on it.  Not sure about a hinge but worth a call and the $$$

Title: Re: Need boat tower fabrication
Post by: Angry Perch on June 18, 2020, 03:00:10 PM

Thanks,
Still a little farther than I'd like. I still need to get a final measurement, as I might be able to squeeze it in by just putting the radar on a hinge or some sort of quick release.

Title: Re: Need boat tower fabrication
Post by: robodad on June 18, 2020, 05:23:57 PM

These guys are very good and closer to you !


https://www.rudnickmfg.com/

Title: Re: Need boat tower fabrication
Post by: millerwheeler on June 18, 2020, 06:16:01 PM

I think whodat towers are great but there prices are crap I had a guy build the exact same tower for half the price of who dat for my tide runner his name is ned 2532529179  call him I'll attach some.photos of my tower

Title: Re: Need boat tower fabrication
Post by: millerwheeler on June 18, 2020, 06:16:55 PM

Here is another

Title: Re: Need boat tower fabrication
Post by: millerwheeler on June 18, 2020, 06:17:19 PM

Last one

Title: Re: Need boat tower fabrication
Post by: The scout on June 18, 2020, 07:42:50 PM

Quote from: robodad on June 18, 2020, 05:23:57 PM

These guys are very good and closer to you !


https://www.rudnickmfg.com/

As good as it gets here!

Title: Re: Need boat tower fabrication
Post by: Angry Perch on June 19, 2020, 09:46:47 AM

Thanks for all the input. Once I get some final measurements, I'll decide how to proceed.