Hunting Washington Forum
Equipment & Gear => Guns and Ammo => Topic started by: CaNINE on July 27, 2020, 03:23:39 PM
-
I ordered a factory brake from Kimber for my 280AI. The brake is pitched 7/16x28. Leave it to Kimber to pick an odd thread pitch. Trying to determine the right tenon to use. Any of you guys install one of these brakes?
-
What do you mean by the right tenon to use?
-
sounds like he's wondering what diameter to turn the barrel down to before threading? :dunno:
-
For a 7/16 thread, that would be 7/16 tenon. You can look up the thread specs for the tolerances.
-
sounds like he's wondering what diameter to turn the barrel down to before threading? :dunno:
Yes this is what I was looking for. We contacted a couple different barrel manufacturers and confirmed .435. It’s a toothpick of a barrel.
-
Leaves you 77 thou wall.... not much, especially after you consider thread depth....pencil barrel is right.
-
If I never post again to this forum you’ll know what happened. :tup:
-
.035 thickness at base of threads. Not much but still would be hold 1500-3000 lbs. shoukd be fine. If not you may end up shooting a 1200 grain brake at your target. Hehe