Resetting 2012 Silverado DIC Messages

[washelkhntr]

Ok, I have a 2012 Silverado and I cant figure out how to reset the "Windshield Washer Fluid Low" message on the Driver Information Center.

I have searched the WWW and cant find anything. And the Owners manual is about worthless, unless you need fire starter.

Anyone have an answer to this?

AND YES, THE WASHER RES IS FULL!

Thanks

[Antlershed]

When the message is on the display, try holding the check mark button down to see if that clears it. Not sure if that is how or not, but that is how you reset the engine oil life % 

[washelkhntr]

Yea I tried that.

And actually, resetting the oil life is done by turning the ignition on, pressing the gas pedal three times within 5 seconds, then starting the engine.

I wish they could just make this crap easy!!!

[hrd2fnd]

Stand on one leg pat your head rub your stomach while hopping up and down chewing bubble gum 

[jackelope]

As far as I know you shouldn't have to reset the low washer warning. Should have a level sensor that turns the light on and off. The oil change light is easy. It's been the same way for 15 years now.

[Antlershed]

Yea I tried that.

And actually, resetting the oil life is done by turning the ignition on, pressing the gas pedal three times within 5 seconds, then starting the engine.

I wish they could just make this crap easy!!!

Hmm...the dealer had me reset the engine oil life on my 2011 by holding down the check mark button and it reset to 100% 

[jackelope]

I can look at all that stuff on alldata  tomorrow and post back on here if needed.

[washelkhntr]

Maybe my sensor is jacked up. I drained the res, and refilled it and the message still stays on.

 

[hrd2fnd]

I can look at all that stuff on alldata  tomorrow and post back on here if needed.

defiantly better answer then I had and nice of you to offer.

[washelkhntr]

I can look at all that stuff on alldata  tomorrow and post back on here if needed.

That would be great! I appreciate that.  Thank you.

[jackelope]

Maybe my sensor is jacked up. I drained the res, and refilled it and the message still stays on.

 

[firefighter4607]

Maybe my sensor is jacked up. I drained the res, and refilled it and the message still stays on.

 

My 07 light went off after I filled it.
Why did you drain the res? Maybe you some how unplugged a wire or something.

[Austrian Hunter]

Must be the sensor,  my 2012 Silverado does it automatically.   Isn't your truck still under warranty??

[jackelope]

This is specific to a '12 Silverado resetting the oil change light. From Alldata.com

ENGINE OIL LIFE SYSTEM

When to Change Engine Oil
This vehicle has a computer system that indicates when to change the engine oil and filter. This is based on engine revolutions and engine temperature, and not on mileage. Based on driving conditions, the mileage at which an oil change is indicated can vary considerably. For the oil life system to work properly, the system must be reset every time the oil is changed.

On some vehicles, when the system has calculated that oil life has been diminished, a CHANGE ENGINE OIL SOON message comes on to indicate that an oil change is necessary. Change the oil as soon as possible within the next 1 000 km (600 miles). It is possible that, if driving under the best conditions, the oil life system might not indicate that an oil change is necessary for over a year. However, the engine oil and filter must be changed at least once a year and at this time the system must be reset. For vehicles without the CHANGE ENGINE OIL SOON message, an oil change is needed when the OIL LIFE REMAINING percentage is near 0%. It is also important to check the oil regularly and keep it at the proper level.

If the system is ever reset accidentally, the oil must be changed at 5 000 km (3,000 miles) since the last oil change. Remember to reset the oil life system whenever the oil is changed.

How to Reset the Engine Oil Life System
The Engine Oil Life System calculates when to change the engine oil and filter based on vehicle use. Whenever the oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where the oil is changed prior to a CHANGE ENGINE OIL SOON message coming on, reset the system.

Always reset the engine oil life to 100% after every oil change. It will not reset itself. To reset the Engine Oil Life System on most vehicles:



Display the OIL LIFE REMAINING on the Driver Information Center. If the vehicle does not have Driver Information Center buttons, the vehicle must be in P (Park) to access this display.
Press and hold the SET/RESET button on the Driver Information Center, or the trip odometer reset stem if the vehicle does not have Driver Information Center buttons, for more than five seconds. The oil life will change to 100%. On all vehicles, the Engine Oil Life System can be reset as follows:
Turn the ignition to ON/RUN with the engine off.
Fully press the accelerator pedal slowly three times within five seconds.
Display the OIL LIFE REMAINING on the Driver Information Center. If the display shows 100%, the system is reset. If the vehicle has a CHANGE ENGINE OIL SOON message and it comes back on when the vehicle is started and/or the OIL LIFE REMAINING is near 0%, the Engine Oil Life System has not reset. Repeat the procedure.

[dewandgin]

Have seen a few sensors get jacked up in the tanks. Especially if they sit empty for awhile. When the tank is full look in front of drivers front wheel behind the fender liner and the tank is right there. sometimes if you smack the sensor with your hand or the handle of a screwdriver it will start working again if not then you need a new sensor. 2012 depending on the mileage might still be under warranty. There is no reset on that system.