5" PVC with a glued cap. Air tight except for the door. 5" is very hard to get but I wanted that size. 4" is too small and 6" would use too much CO2.


The working parts of the trap slide out to load bait or remove civet.

Just set the trap and slide the working parts back in.I drilled a small hole in the PVC so I could wire the door frame to the pipe. I thought a civet might push it out. It is a pretty tight fit and found out the wire is not neccesary so I just push it in and good to go.

How it looks when set. Door is on the side. Pan on the bottom although you can't see it. When you make a catch just tip the trap up carefully. Remember you have a skunk in there! Then insert hose from CO2 bottle through door and crack the valve while you count to 30. Wait about 10 minutes and dump out dead civet.
