Homebrew Trailcameras

[Machias]

WASHBC Do you think you will need the seal around the inside edge of the case?  Just a thought.

[WASHBCBOOK]

hey guys i dont need a hole for the flash and yes i still need to add a reduce around the camera lens all in all i guess not to bad

[gkowen]

I would think the case is going to diffuse the flash and decrease the range.  I would test the camera in the case and out to see if the flash is as good in the case.  Also, I have a feeling the focus assist will light up the whole case. But if you have tested it, I guess it must work.

[Skyvalhunter]

Someone might walk away with this one.

[bearbait]

What type of store should I go to to get the 1"x1" aluminum angle for the camera mount on the homebuilt?

[div4gold`]

What type of store should I go to to get the 1"x1" aluminum angle for the camera mount on the homebuilt?

Ace Hardware, etc has that kind of stuff.

[bigdave]

Home depot has it

[Machias]

I have some you can have. 

[Craig]

Sure is getting harder to find cheap cameras on ebay. 

[bigdave]

We think only people from WA read or know about this site. The internet is global. I am careful what I type on here because of that.

Camera prices have gone up about 35-40% since Jan end of Dec.

Pretty amazing.

[Grizzly95]

For the camera shelf in the box, I just used some scrap steel and bent it. Then I used rivets to attach it.

[Skyvalhunter]

Hey Bob what happened to your posts on Pixie controller website about solder locations?

[BobR]

Keith,  Your camera will be in the mail tomorrow. Here is a pic showing the solder locations.

Red - power
Black - ground
Green - shutter

[BobR]

Keith,  Sorry, I can't get that pic to work. You will find what you are looking for on page 16 of this thread.
Bob

[Craig]

Anyone ever try movie mode with a W80?