Powder Help!!!

[Bowtech7]

Okay so I'm probably over thinking it but got a new CVA accura v2 and it specifically says up to 150 grains of powder by volume....But I've been weighing powder wrong in the past by 100 grains of weight. So my question is is there an conversion chart for triple 7 ffg and pyrodex rs select to figure out how much powder by volume I should use or is equal to 100 grains of weight. I was going to weigh my powder out on a scale to have accurate measurements. Any help is appreciated

[bobcat]

I'm a little confused by your question but black powder is supposed to be measured by volume. You do have a powder measure, right? I suppose it doesn't hurt to weigh it after you measure out 100 grains by volume, but it's not necessary.

[Blcktaildreamer]

I think he does not have a measure and has been weighing it.


Sent from my iPhone using Tapatalk

[bobcat]

I found this conversion chart:

http://www.curtrich.com/BPConversionSheet.htm

[Bowtech7]

I reload rifle bullets also and have been weighing a 100 grains of black powder on my rcbs scale as I would if I weighed smokeless powder and just realized today 100 grains of black powder is not 100 grains by volume. I have some plastic pre measure tubes and filled it to the 100 grain by volume line with triple 7 ffg and weighed anywhere from 77 to 84 grains of weight So my question is how much black powder should I use in grains of weight so I can measure it out on my scale. Bobcat I looked at that chart and it didn't have pyrodex select on it only p for pistol.

[Timberstalker]

Why can't you just buy a black powder measure and do it by volume?

[Bowtech7]

I guess I could but I'm not sure what those look like

[Timberstalker]

http://www.midwayusa.com/black-powder-measures/br?cid=23205

Look through these.

[Timberstalker]

Or better yet, shoot pellets.

[HntnFsh]

Or better yet, shoot pellets.

Why take a step backwards?

[Timberstalker]

Or better yet, shoot pellets.

Why take a step backwards?

I won't derail this thread over this nonsense.

[sled]

I have the same rifle and found 100 gr of ffg shoots the best for me by far.  Pick up a powder measure and go that route.

[Bowtech7]

Sled that's what I'm going to do now that I have done research. Thanks for the helpful input

[HntnFsh]

Or better yet, shoot pellets.

Why take a step backwards?

I won't derail this thread over this nonsense.

Pellets are harder to ignite. More prone to draw moisture. And can't dial a load in as well as loose powder. Sure seems like a step backwards to me. I think the o.p. has the right idea about getting  a powder measure and going from there with loose powder.

[Timberstalker]

Sure.  Notice I recommended a link for the powder measures.

To the OP, best of luck getting this dialed in.

And don't stop posting because of the few jackwagons! People generally help out on this forum.