Shots are breaking down and to the right

[CP]

My arrows all seem to break down and take hard right just before hitting the target, like a Randy Johnson slider.  I don’t think Mr. Snappy is going to get the job done.  Any advice on how to correct? 

[Lucky1]

That’s a tough one. Maybe get some help from a good bow shop?
Could be lots of things. Is the rest centered vertically and horizontally? Arrows have the right spine for your draw weight and length? Are the fletches hitting the cables or your rest? Are you torquing the bow when you shoot?
I could not get my bow tuned up to where my field points and broadheads would hit in the same spot until I yoke tuned the top cam so it is canted a little bit. Now the arrows launch straight and the field points and broadheads hit the same. I shoot a Hoyt bow. I did switch to heavier shafts too, I think that was part of the solution for me.
Good luck.

[andersonjk4]

Have you shot through paper up close?

[CP]

Have you shot through paper up close?

No, nothing that sophisticated.

[MADMAX]

Broadheads or field points ?

[CP]

Broadheads or field points ?

Field

I did just put lighted nocks on - could that be the problem?

[Wolfdog2314]

Everyone has their own opinion on tuning their bow. But I did this, bare shaft tune this year, and my bow has never shot better.

https://argalioutdoors.com/advice/broadhead-tuning-101-how-guide-bare-shaft-tune-any-bow?mc_cid=59279c81e2&mc_eid=43c0b8599d

[rooseveltkiller]

Look up levi morgan on youtube and he will set you free. Im sure he will teach you more then most guys on here can. Straight shooting 

[buckfvr]

Broadheads or field points ?

Field

I did just put lighted nocks on - could that be the problem?

If your FOC was marginal to begin with, then yes adding lighted nocks will throw you off.  Read about FOC to figure if it is indeed affecting your shots. 

[CP]

Broadheads or field points ?

Field

I did just put lighted nocks on - could that be the problem?

If your FOC was marginal to begin with, then yes adding lighted nocks will throw you off.  Read about FOC to figure if it is indeed affecting your shots.

That must be the problem.  I put the old nocks back on and the problem goes away.  I also have a few cheap Walmart arrows that don't seem to be affected by the heavier nocks. 

[CP]

Thanks for all the help, looks like I'm back in business.   

[dilleytech]

Learn to tune your bow. Bareshaft tuning is easy to figure out and you can do it in your yard without paper.

[blackveltbowhunter]

Thanks for all the help, looks like I'm back in business.   

What was the issue?

[Taco280AI]

Has this always been an issue, or just recently?

[jstone]

What kind of rest do you have?