Other Hunting > Waterfowl

Birdshot detection

<< < (3/4) > >>

Special T:

--- Quote from: h2ofowlr on May 02, 2024, 07:16:11 AM ---I have had good luck with the Garrett Pinpointer.  I have a 2'x3' piece of Teflon cutting board and I lay the breasts and legs out on it and just go over each piece.  Never nice bitting into shot or running it through my grinder.

--- End quote ---

This is what I use as well, not cheap but a cracked tooth is more expensive.

wadu1:

--- Quote from: h2ofowlr on May 02, 2024, 07:16:11 AM ---I have had good luck with the Garrett Pinpointer.  I have a 2'x3' piece of Teflon cutting board and I lay the breasts and legs out on it and just go over each piece.  Never nice bitting into shot or running it through my grinder.

--- End quote ---

This is not a bad idea. Plenty of them on the market, Garrett, Minelab even Hobofrieght.

mboyle0828:
Thanks for the recommendations guys. Just pulled the trigger on the Garrett Pinpointer

ghosthunter:
Anyone ever tried a regular stud finder?

Just thinking out of the box. :dunno:

jamesfromseattle:

--- Quote from: mossback91 on May 01, 2024, 08:27:59 PM ---Teeth! I only run bismuth now so it’s like popping a tums with dinner! :dunno: :chuckle:

--- End quote ---

I also run Kent bismuth but sometimes it’s tough to find. Does anyone know how the copper plated bismuth is on the teeth?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version