Do you have any problems with flething clearence?
Yes I did,but it wasn't the rest, it was the way I had it set up. I talked to a mathews tech(Crunchy gave some good info also)and he gave me the specs for a good starting point and I have not had a problem since. Set center shot, making sure berger hole lines up with the center of the arrow shaft.Then measure out from berger 11/16(mathews tech said this is a good starting point for all single cam bows).Then paper tune,should be good to go. You can test by spraying foot powder on your vanes.They make a few that don't have a smell
and some that leave a smell for a long time
