Arrow, vane and glue Combos?

[RIVERRAT]

I am trying new combinations of arrows (maxima hunter), vanes (flex fletch), glue (flex bond) and just picked up a new Bitzenburger helical jig.  What combos are others using?   I really like the flex fletch and may try the ACC pro hunters but I am not really impressed with the glue.   I lost a few vanes today when I 10 ringed some old bails at my local walk through and they went vane deep.    Maybe I should just be using some old arrows for this type of shooting and using my good arrows only on 3D and hunting.  Thoughts?

[carpsniperg2]

I run the vanetec hp's. A 2" high profile vane like the blazer. I did not like the blazers because of the bases being flat. I guess they fixed it but I won't switch back any time soon. I run a high color wrap orange and white for the most part. I also shoot goldtip xt's 5575's with my 4 fletch setup. Crank up the offset and let them fly

[mallard79]

I am using goat tuff glue on everything.....I love it....especially compared to fletch tight and a couple others that i have tried....

[hughjorgan]

Easton fmj's with blazer vanes with a helical and i am using loctite gel super glue. Works better than goat tuff and is way cheaper, IMO.

[wrongway]

I use AAC max bond glue and vanes, for both my target and hunting set up. I have never had one come off yet and you dont need to prep the vane like you do with flex fletch

[JBar]

Are you using wraps RIVERRAT? If not try roughing up your your arrows a bit with some 440 grit sandpaper then clean with Acetone. U know what I am using so if you have any other questions give me a call. PM sent

[Weehunt66]

Has anyone used  Flex Tite Platinum on Blazers and Easton Axis?

[dbbowstrings]

i use goattuff for quick repairs ....for platinum i wipe the shaft and vein with MEK let set for a minute apply vein leave in jig for 5 to 10 min. deppending on how much of a hurry i am in.

[JLS]

I use Gorilla Impact Super Glue.  I've also used Loctite Super Glue Gel.  Both work well.

Your issue might be the Flex Fletch vanes.  My buddy uses them and there are some very particular steps he says you have to follow to get them to bond well.

[sakoshooter]

Has anyone used  Flex Tite Platinum on Blazers and Easton Axis?

I've been using the Bohning Fletch Tite and Blazers on Beman ICS Hunters with no problems. Using a Bohning Blazer Helical Jig also.

[JLS]

Also, to more specifically answer your question on glue, I have used Fletch Tite Platinum.  I had no problems with it, other than it takes a while to set.  I can fletch arrows much faster with my Bitz using the Gorilla Glue.

If you're trying to put some helical/offset on your Blazers with the Platinum, I'd leave it in the jig for about 5-10 minutes to make sure it's getting a good set.

[coachcw]

maxima hunters , four fletch blazers, goat glue , 100 grain tips !

[LeeMajors]

Maxima 350, blazer vanes, G-5 Blue Glue, Bohning Blazer Jig.  I have to add (hopefully) lighted nocks as my arrows are under 400 grains right now   

[wrongway]

Again try Max Bond glue, you only need to clean the shafts NOT the vanes. the glue is set in 15-20 secounds. You can shoot the arrows in 10 min

[RIVERRAT]

Thanks for all the input guys!!