Problem with accuracy 😳

[elkaholic123]

I can't figure out my problem 

[Henrydog]

Wasn't everyone's first welding project in metal shop a mini 14?

[jackelope]

It's because it's a mini 14!

[HawkCreek]

I don't see any color on the threads try lock tight, always lock tight the threads on a scope!

Also, replace the nuts with walnuts so you can quickly switch to irons without tools if your optic goes down!

[Mtnwalker]

I'd check the torque on those ring screws. Everything else looks good

[CP]

You should try welding the rings to the top of that riser; and remember, “the bigger the gob the better the job”.
 

[timberfaller]

  stupid is as stupid does!!

[baker5150]

Scope should be welded to the rings, wont move that way.

[Fl0und3rz]

RIP, mini 14.

[timberghost72]

Should have used stainless scope mount brackets. Welding standard metal brackets to a stainless receiver is the real problem. 

Some JB weld AND a larger glob of weld should be good for a temporary fix.

[Milkman]

Should have went with JB Weld instead

[2MANY]

It's the way you are holding the gun.

[kisfish]

The lack of duck tape is clearly problem. Quarter roll should get that back to sub moa

[high country]

Those minis shoot best with a 20moa dot reticle.

[JDHasty]

Might want to take a good look at the barrel.  It may need to be re-crowned or straightened.  Easy to do at home with a few commonly found tools.