collapse

Advertisement


Author Topic: broadhead accuracy question  (Read 6506 times)

Offline bullcanyon

  • Non-Hunting Topics
  • Trade Count: (+1)
  • Sourdough
  • *****
  • Join Date: Jun 2007
  • Posts: 1293
  • Location: Lewiscounty
Re: broadhead accuracy question
« Reply #15 on: August 25, 2009, 06:22:35 AM »
Don't waste your time paper tuning.  That just gets you started.  Broadhead tuning is more of a "finisher".  Look up the easton tuning guide and follow the steps for broadhead tuning and you will be money.  Minor adjustments at a time.  Don't worry about your sight until you get the fieldtips and broadheads to hit as close as possible.

Offline MagKarl

  • Political & Covid-19 Topics
  • Trade Count: (0)
  • Scout
  • ****
  • Join Date: Apr 2008
  • Posts: 459
  • Location: Olympia, WA
Re: broadhead accuracy question
« Reply #16 on: August 25, 2009, 08:36:34 AM »
It sounds like your tuning is close and you're shooting good groups with field points.  You often need to tune a little bit more for broadheads.  As suggested before, chase the field points with the broadheads.  Move your rest up and left a bit and see if the gap closes. 

Keep chasing it till you group together and then dial in your sight to move the group to center. 

Offline Kain

  • Scalpless
  • Trade Count: (0)
  • Old Salt
  • ******
  • Join Date: Sep 2008
  • Posts: 5859
  • Location: Vantucky, WA
  • VantuckyKain
Re: broadhead accuracy question
« Reply #17 on: August 25, 2009, 02:46:38 PM »

Offline Tom Tamer

  • Trade Count: (0)
  • Longhunter
  • *****
  • Join Date: Mar 2007
  • Posts: 624
  • Location: Black Diamond, Wa...or the Pine ridges of the Cascades
Re: broadhead accuracy question
« Reply #18 on: August 29, 2009, 06:05:13 PM »
Thanks for the tips, I will get to work on it. Crunchy, where should I go to get paper tuned?


In your back yard!  Make yourself a frame to set in front of your target that you can stretch some paper on and stand about 6 feet in front of the paper and shoot through it.  Do some searching around on the net and you will find lots of info.

-Lowedog

 I use a ladder and small bungy cords to hold the paper tight.....I figure at 6 feet if i hit the ladder it's my own damn fault....works great.

 If it tunes fine and you have the same problem my Pro told me......move the pins to match the broads.....field points ain't what we're using this time of year
Luv 2 Hunt no matter the weapon
Mathews outback,easton axis,G5 montecs, Mod 70 7MM rem mag, T/C Black Diamond 50 cal...
Wild turkey addict( bird that is)
Everything is best in moderation....even moderation

Offline TheKid#10

  • Non-Hunting Topics
  • Trade Count: (0)
  • Scout
  • ****
  • Join Date: Dec 2007
  • Posts: 363
  • Location: Puyallup & Chinook Pass, WA.
  • Bullwhisperer
Re: broadhead accuracy question
« Reply #19 on: August 30, 2009, 05:21:44 PM »
[[/quote]
 If it tunes fine and you have the same problem my Pro told me......move the pins to match the broads.....field points ain't what we're using this time of year
[/quote]

That's what I was told by a local pro shop,  so that's what I did.

Thanks for all the tips and help folks.

Good luck and shoot straight.

KID
"Success: You get out, what you put in." - TheKid#10

Offline bullcanyon

  • Non-Hunting Topics
  • Trade Count: (+1)
  • Sourdough
  • *****
  • Join Date: Jun 2007
  • Posts: 1293
  • Location: Lewiscounty
Re: broadhead accuracy question
« Reply #20 on: August 30, 2009, 08:39:59 PM »
That's too bad.  Only takes a tiny bit of effort to get your broadheads to fly better.  One question.  Are you getting all your arrow/broadheads to hit the same spot?  Or do you have some flyers?

Offline Bowcop

  • Trade Count: (0)
  • Tracker
  • **
  • Join Date: Aug 2009
  • Posts: 38
  • Location: Blaine
Re: broadhead accuracy question
« Reply #21 on: August 30, 2009, 11:42:18 PM »
More people have quit archery over papertuning than any other reason...........it plain sucks! If you don't like the tear move back or forward 3 more feet and you will have a different tear! I use the walkback method with my broadheads. I start with field tips at 20 yards and move my sight to where I am hitting a 2 inch bullseye with every arrow (if you have 1 or 2 arrows that are out of the group rotate the nock 120 degrees until it hits with the rest of them. Once you have done that....sometime this takes hours to get 6 arrows to hit the same spot.  Once that is done shoot a broadhead @ 20 yards and see where it hits (I only shoot 1 BH at a time and then pull...I get SICK of refletching arrows!

Now the BH will most likely hit a wee bit off from the field tips...it is a RARE bow that will put field tips and BH in the same hole at 20 yards. Now...if for example the BH is 3 inches low and right of the FT, every so slightly move your arrow rest to the left and move your sight down just a hair until you hit center with the BH....

Once you have that done do NOT adjust your sight housing anymore...Now make sure that all your BH's hit the center @ 20 yards...you will have to do alot of nock rotating to get say 4-5 that will be darts for you. (out of a dozen arrows I usually only get 4-6 that are up to my accuracy standards for BH..but I am VERy picky when it comes to this.

Now move to 30 yards and use your 20 yard pin...your arrows will obviously hit low, but that is OK. Most likely your arrows are going to be left or right of the center....now it is just a matter of very small adjustments R or L to your arrow rest. Move the rest in the opposite direction...IE, arrows are hitting right of center, move the rest left..very small adjustments are key here....

Then do the same @ 40 yards again using your 20 yard pin...once you have all your BH's hitting center your centershot is now set...crank your rest down so it will not move...now go back and sight in your pins for those distances......works like a champ and has never failed me....I can put  all of my BH in a two inch bullseye at 50 yards...if you need anything else....just ask! Like some of the others mentioned, make sure your grip is loose and consistant...very critical for BH flight...and make sure your anchor point is not floating around...I have 3 references for my anchor point, my peep, my kisser button and my nose on the string, if you don't have 3 points to keep you consistant...your gonna have issues.....Take it from an archery coach!

Tim
« Last Edit: August 31, 2009, 08:53:32 AM by Bowcop »
Team PSE

 


* Advertisement

* Recent Topics

Honda BF15A Outboard Problems by Sandberm
[Today at 08:18:08 PM]


Idaho General Season Going to Draw for Nonresidents by JDArms1240
[Today at 08:16:36 PM]


Hoof Rot by TitusFord
[Today at 07:59:17 PM]


Ever win the WDFW Big Game Raffle? by JDArms1240
[Today at 07:09:31 PM]


Eastern WA-WT hunting from tree stands?? by addicted1
[Today at 06:47:44 PM]


A question for any FFL holders on here by ryan2202
[Today at 05:01:26 PM]


MA-10 Coho by CP
[Today at 04:14:05 PM]


Bow mount trolling motors by BigGoonTuna
[Today at 01:29:55 PM]


I’m on a blacktail mission by addicted1
[Today at 12:10:11 PM]


where is everyone? by nwwanderer
[Today at 06:01:04 AM]


Wolf documentary PBS by Skyvalhunter
[Today at 05:58:56 AM]


Stuffed Pork Chop by EnglishSetter
[Yesterday at 11:12:59 PM]


Another great day in the turkey woods. by Remington Outdoors
[Yesterday at 09:43:57 PM]


Buck age by kentrek
[Yesterday at 08:56:47 PM]


Oregon special tag info by Judespapa
[Yesterday at 08:37:07 PM]

SimplePortal 2.3.7 © 2008-2025, SimplePortal