Enlarging (Milling) an AR15 Ejection Port

[6.8mmARHunter]

I'm building an AR-15 upper receiver in  .458 SOCOM. The ejection port on the upper receiver that I'm going to use needs to be enlarged.

I need to enlarge (mill) out the ejection port on it. I need to have 0.020" milled off the top edge and 0.095" milled off the bottom edge of the ejection port.

Does anyone know of a machinist/gunsmith around Western Washington that could do that for me?

Thanks,


sam

[Biggerhammer]

Call Benchmark barrels, they may be able to do it. I know they can, I just don't know if they will enlarge a ejection port for someone.

http://www.benchmark-barrels.com/Benchmark_Barrels/Benchmark_Barrels_-_Contact.html

[Todd_ID]

I just did mine for a .50 Beowulf with a Dremel, flat file and then fine sandpaper. It wasn't professional but it looked fine and works fine.