collapse

Advertisement


Author Topic: Best sights for my T/C .50 cal Xr?  (Read 2942 times)

Offline trophyhunt

  • Forum Sponsor
  • Trade Count: (+11)
  • Legend
  • *****
  • Join Date: Nov 2008
  • Posts: 20018
  • Location: Wetside
  • Groups: Wa Wild Sheep Life Member
Best sights for my T/C .50 cal Xr?
« on: February 13, 2015, 11:16:40 PM »
I took off the stock fiber optic sights and put on a Williams peep.  I had decent shots with the sight, it felt better than the stock sight but, it seemed the target was in the center of the circle with just a feeling of when to pull the trigger.  Not as confident like a cross hair lining up with the target.  During the late muzzy deer season I fell on my sight and bent it.  So, I'm wondering, what is the best sight on the market in your opinion?  Thanks
“In common with”..... not so much!!

Offline jrebel

  • Non-Hunting Topics
  • Trade Count: (+25)
  • Explorer
  • ******
  • Join Date: Feb 2008
  • Posts: 11518
  • Location: East Wenatchee
Re: Best sights for my T/C .50 cal Xr?
« Reply #1 on: February 14, 2015, 12:01:19 AM »
Nothing better than the Williams peep with stock fiber front.  Depending on your load it can be sighted easily to 180 yards.  When I get home I will add an illustration showing how I use mine.  Amazingly accurate with practice. 

Offline trophyhunt

  • Forum Sponsor
  • Trade Count: (+11)
  • Legend
  • *****
  • Join Date: Nov 2008
  • Posts: 20018
  • Location: Wetside
  • Groups: Wa Wild Sheep Life Member
Re: Best sights for my T/C .50 cal Xr?
« Reply #2 on: February 14, 2015, 12:10:46 AM »
Nothing better than the Williams peep with stock fiber front.  Depending on your load it can be sighted easily to 180 yards.  When I get home I will add an illustration showing how I use mine.  Amazingly accurate with practice.
thanks, would like to see the diaphragm.  Do you line up the front pin in the center of the ghost ring?  I was thinking if I replace the bent peep with a new one to put the front sight on the bottom of the ring for consistency?
“In common with”..... not so much!!

Offline jrebel

  • Non-Hunting Topics
  • Trade Count: (+25)
  • Explorer
  • ******
  • Join Date: Feb 2008
  • Posts: 11518
  • Location: East Wenatchee
Re: Best sights for my T/C .50 cal Xr?
« Reply #3 on: February 14, 2015, 12:16:29 AM »
Always center the post....your eye will naturally do it.  There are a few sight landmarks I use when taking longer shots, though it is just reference as your eye will naturally center the post.  There are many studies that support this.

Offline trophyhunt

  • Forum Sponsor
  • Trade Count: (+11)
  • Legend
  • *****
  • Join Date: Nov 2008
  • Posts: 20018
  • Location: Wetside
  • Groups: Wa Wild Sheep Life Member
Re: Best sights for my T/C .50 cal Xr?
« Reply #4 on: February 14, 2015, 12:24:03 AM »
Always center the post....your eye will naturally do it.  There are a few sight landmarks I use when taking longer shots, though it is just reference as your eye will naturally center the post.  There are many studies that support this.
That is exactly what I thought, I guess it's just having confidence that it is centered.  It feels centered most the time, the last time I took it to the range I didn't do so well.  The time before, it was real accurate.  I probably just need more practice, I also just want to make sure it's the best sight to have on a gun that I will be hopefully using for a tag that I've waited 19 years to draw.  Thanks for your help and I'm wondering if others have any other opinions. 
“In common with”..... not so much!!

Offline jrebel

  • Non-Hunting Topics
  • Trade Count: (+25)
  • Explorer
  • ******
  • Join Date: Feb 2008
  • Posts: 11518
  • Location: East Wenatchee
Re: Best sights for my T/C .50 cal Xr?
« Reply #5 on: February 14, 2015, 09:31:25 AM »
Here is my set up, I am assuming the same as yours. 

I shoot 110 grains pyrodex with 250 or 300 grain Shockwaves. 

The last picture shows my holds for my ballistics using the 250 grain bullets.  For anything past 100 yards I use certain landmarks to make sure everything is squared up and centered.  When I look through my peep I can line up the bottom of the peep aperture with the screw hole on the front site.  The screw hole on the front site will look like a horizontal line that is slightly curved.  When lined up my front post is centered exactly....and this is just confirmation for again my longer shots. 

Everyone's eyes are a little different.....so play around and figure out what works best for you. 

Hope this is helpful. 

Offline trophyhunt

  • Forum Sponsor
  • Trade Count: (+11)
  • Legend
  • *****
  • Join Date: Nov 2008
  • Posts: 20018
  • Location: Wetside
  • Groups: Wa Wild Sheep Life Member
Re: Best sights for my T/C .50 cal Xr?
« Reply #6 on: February 14, 2015, 09:41:48 AM »
thanks, I need to get the sight ordered and do some more shooting.  Doesn't seem to be too many other sights recommended.  :tup:   I use 100grains of xxx7 pellets with a 290 grain bullet.
“In common with”..... not so much!!

Offline usmc74

  • Non-Hunting Topics
  • Trade Count: (+2)
  • Sourdough
  • *****
  • Join Date: Mar 2009
  • Posts: 1380
  • Location: North Bend
  • Groups: NRA (Life), RMEF, SAF (Life), American Legion (Life), Master Hunter
Re: Best sights for my T/C .50 cal Xr?
« Reply #7 on: February 14, 2015, 12:12:14 PM »
That is my basic sight picture and holds

I shoot T7 3F(110gr), Barnes 290 TMZ out of my Bighorn

Offline trophyhunt

  • Forum Sponsor
  • Trade Count: (+11)
  • Legend
  • *****
  • Join Date: Nov 2008
  • Posts: 20018
  • Location: Wetside
  • Groups: Wa Wild Sheep Life Member
Re: Best sights for my T/C .50 cal Xr?
« Reply #8 on: February 22, 2015, 04:02:27 PM »
Ordered my Williams peep from midway, should be here in a couple days!  Thanks for the tip!
“In common with”..... not so much!!

 


* Advertisement

* Recent Topics

Drew Pogue Quality by Buckblaster
[Today at 10:29:34 AM]


Break my heart - Archery World is closing by pianoman9701
[Today at 10:07:25 AM]


Aladdin unit 111 mule deer quality tag by jamesjett
[Today at 09:44:20 AM]


211 Mile Ambler Road Through The Brooks Range Approved by Chesapeake
[Today at 08:44:28 AM]


GM 6.6l gas 6 speed vs. 10 speed? by HntnFsh
[Today at 07:39:54 AM]


2024 Ford Edge Opinion/Bought a Chevrolet by NOCK NOCK
[Today at 05:14:27 AM]


What are you cooking? by Pnwrider
[Yesterday at 10:27:08 PM]


My 2025 Montana Buck by JDArms1240
[Yesterday at 10:18:25 PM]


Where to find hunting mentors/etc in western wa (archery) by high_hunter
[Yesterday at 08:14:54 PM]


2025 deer, let's see em! by MADMAX
[Yesterday at 08:10:14 PM]


AMMO 6.5 PRC 143 Gr ELD-X Hornady by dblungshot
[Yesterday at 06:38:26 PM]


Spotting scope mounting plate by Crunchy
[Yesterday at 04:36:19 PM]


High n Dry gear by Pete112288
[Yesterday at 03:30:29 PM]


Pants for wet brush? by Humptulips
[Yesterday at 03:06:03 PM]


My 2025 Wyoming trip by REHJWA
[Yesterday at 01:03:15 PM]


Bobcat Scent Lures on the Westside by Humptulips
[Yesterday at 11:41:38 AM]


What are some good 12 ga factory loads for predators? by Kingofthemountain83
[Yesterday at 11:22:03 AM]

SimplePortal 2.3.7 © 2008-2025, SimplePortal