muzzleloader elk

[panzerROT]

To all you muzzleloader geeks out there, I have drawn a mt view any bull permit for the blues. I am not an expert by any means with my Vortex light northwest traditions muzzleloader. I have been practicing at 100 yards. My combo is pyrodex pellets 2-50 gr. with powerbelt 295 hollow pts. I'm using 1081 german caps. my first shot I hit 2 inches to the left and 2 inches low. I was pumped! however my next shot was 16 inches low and 2 inches to the left. So I have cleaned my gun at 3 to 4 shots. Everytime I clean the first shot is right on but the 2nd falls 16 inches. I realize on the range I can clean every shot not so in a hunting situation.  The 2,3,4 shot are consistent at 100 yards at 16 inches low. Should I go into the field with a fresh barrel or should I go with the first shot taken. Or am I not cleaning the gun properly? I realize the 2nd shot will loose energy. Or would a hotter load be better say 120 grain? Anyone out there have advice. Keep in mind I live in Washington. Thanks

[Harleysboss]

Why cant you clean in the field? I carry a few small prepacked alcohol wipes with me in my pack. I always do a quick wipe with the alcohol patch and then a dry patch prior to reloading. Reloads are slow anyway with the muzzy so why not prep your gun the same shot every shot. I dont have first hand knowledge of your gun so maybe others will have more info for you. Loose powder and a better bullet than the Power Belt may be something you may want to investigate.  The 295grn HP PB is not a great Elk Bullet in my opinion. If you like PB bullets maybe a Platinum series would be a better choice for Elk. Elk are tough critters and HP PBelts are not.

[Stein]

Tough question, if it was a modern rifle the choice would be obvious, but leaving black powder residue in a gun is not a great thing.  I would likely be tempted to go in clean and then just hold over for a second shot if it was needed quickly.  If it goes off and you leave it for a while before tracking, you could clean it in that circumstance.

[10thmountainarcher]

Using pyrodex pellets I have never been able to group. I would try loose. Try different combos of bullets and powder till u find one that works.

[floatinghat]

when you say "clean" is that a swab or a bunch of swabs?  My POI from clean to fouled move about 2 down and 2 right.  However, open sights and measuring powder by volume always leaves a little wild card.  I use loose, swab once with a light spit on a patch.  After the first patch I group in the same. 

Has the "clean" barrel been fouled by a couple of caps?

[panzerROT]

when you say "clean" is that a swab or a bunch of swabs?  My POI from clean to fouled move about 2 down and 2 right.  However, open sights and measuring powder by volume always leaves a little wild card.  I use loose, swab once with a light spit on a patch.  After the first patch I group in the same. 

Has the "clean" barrel been fouled by a couple of caps?
When I say clean I mean taking out the plug clean the barrel spotless with wire brush etc. swab several times. Maybe I will just try swabbing once and re-shooting. The gun has never mis-fired in all the shooting ive done.

[panzerROT]

hey floatinghat, I think the next trip to the range I'm going to try loose powder with a traditions 350 lead lubed, I will shoot the first shot and leave the fouling. The 2nd and 3rd and 4th shot I will spit swab in between each. Do you use a slotted jag with a spit on one side swab and then flip over to dry swab again and then shoot. leaving the breech plug in correct?  Thanks for the reply

[bighorn1]

I have the same gun I think your answer is go to lose powder instead of the pellets.

[meatwhack]

If you aren't fouling the gun first with a primer I'd try that and then shoot a group. There's no reason you shouldn't be able to shoot 3 to 5 shots with consistent accuracy.

[Mallardmasher]

Pyodex is dirty, and I have not had much luck with Powerbeats and dirty barrels, I have switched to triple 7 pellets and Barnes MTZ , and now I am good for about 5 shots before swabbing.

[sled]

Loose the pellets, and power belts.

[JL]

I am not an expert either but I've shot a lot this year for similar reasons. I'm letting one go right before I head out for the hunt.

[funkster]

Pyodex is dirty, and I have not had much luck with Powerbeats and dirty barrels, I have switched to triple 7 pellets and Barnes MTZ , and now I am good for about 5 shots before swabbing.

I agree with using triple 7 and Barnes MTZ. I've also found some guns shoot better using loose over pellet. I can usually shoot 5 rounds before the MTZ's get hard to load. Also make sure and shoot a cap before loading (fouling the barrel). When you take to the field, make sure you're acclimating your gun properly. I actually leave my loader in the rig so I'm not creating moisture in the barrel going from hot to cold. It essentially stays at an even temp or gradually heats to air  temp more even. Good luck, loading is a lot of fun but can also be a bit finicky. A user on this forum (I believe named sabot loader) has a lot of good info, might want to give his threads a look.

[WAcoyotehunter]

Has the "clean" barrel been fouled by a couple of caps?

Foul your barrel more before your first shot.  Hopefully it's low and consistent, like your second shots have been

[CP]

Loose the pellets, and power belts.

 

And keep your bore clean and oil free.

[floatinghat]

hey floatinghat, I think the next trip to the range I'm going to try loose powder with a traditions 350 lead lubed, I will shoot the first shot and leave the fouling. The 2nd and 3rd and 4th shot I will spit swab in between each. Do you use a slotted jag with a spit on one side swab and then flip over to dry swab again and then shoot. leaving the breech plug in correct?  Thanks for the reply

This what I do,  I'll run a dry patch a couple of passed in a clean and maybe lightly oiled bore.  Then I snap 3-4 caps, then I load my powder, sabot/PRB/wad/conical and shoot. My swab is I lick a patch and run it twice and repeat loading.  This is my cycle, if a the range I crack open my breech plug every 8 to 10 shots (T73F).  When home I do a complete cleaning.

Let us know if that helps.

[Dirty Mike]

Loose the pellets, and power belts.

 

[GUscottie]

I switched to loose powder and the platinum power belts...worked wonders for me