As in my earlier post about getting my Marlin .22 mag back that was stolen and in non-functioning condition, I have since gotten it relatively cleaned up and firing.
Have an issue with it extracting a fired case, but likely needs the chamber better cleaned up with and polished and the bolt torn down for a deeper clean as well.
What I am thinking about is that since I replaced it right after the theft with a new Marlin .22 mag, I really don't need two.
Looking to see if anyone has any idea on the feasibility of having the barrel bored clean and a new sleeve installed in .17 HRM and where something like that could be done, if it can be done??
I know the Marlin barrel is pinned in and possibly "glued" as well and would like to talk with a gunsmith that is familiar with this process, so hoping for some recommendations.
In the meantime, pulled the moldy wood stock out of an overnight soak in white vinegar and got the bulk of the "live" mold off. After air drying will check it to make sure it doesn't have any big warps or other damage then start refinishing it if it is good to go.
Thanks much!!
