So here is the deal...

[BigGoonTuna]

i was talking about the hand press.  it takes the standard dies, and since i plan on just neck sizing my brass i wouldn't think it'd be too much of a chore.

[AWS]

I have one of those Lee scissor type hand presses.  I use it to size pistol and small stuff like 22H and 218Bee.  If you get the kit it is a pain to prime with the ram prime, pick up a hand primer.  Seating bullets is another one where you wish you had a third arm coming out the midle of your chest.  The little Lee "C" press mounted on a board that you can clamp to a desk would be handier.

AWS