Tuning carbon shafts for a longbow

[quadrafire]

I have some new unfletched shafts that I need  to get busy on. I was gonna bareshaft test some. Can I glue in my insert then cut from the back of the shaft if needed. I have used plastic wrap around the insert for a temporary fix, but have lost some in the target when pulling.
Any thoughts?

[Webfoot]

If they have the push in pull out nocks you want to bareshaft and cut from the back if you have your inserts glued in.

John

[NWWABOWHNTR]

Use hotmelt on your inserts... if you need to cut then all you do is stick the end in hot water and then pull out the insert.