High-Standard sportking jamming!

[Karl Blanchard]

So I picked up a N.I.B. High-Standard Sport King for $250 the other day   took it out yesterday and it would not cycle worth a darn.  I think it is the clip but can't be sure.  Does anyone have any experience with them and this problem?

[Karl Blanchard]

another

[ICEMAN]

Wow, that copper looks bent....from here atleast...

[JLS]

Have you tried different ammo?  First guess is a faulty magazine lip.

[SemperFidelis97]

That looks to be a .22 what kind of ammo are you using? With my walther P-22 I have to use high velocity ammo to have it cycle properly, also lube the heck out of it.

[Karl Blanchard]

It is super clean and well oiled.  Everything I have read says don't use high velocity stuff in these old models.  It would do this about every 4 or five rounds with both federal and remington ammo.  It would bend the heck out of the bullet! I read a few things about it and it sounds like a mag problem.  One guy talked about "modifying the clip" with pliers but didn't go into detail.  When it cycled it shot AWESOME!!!!!

[JLS]

Do you have more than one magazine?  If so, use it and see if you can replicate the problem.

Also, it may just need 100 rounds through it to break it in. 

[Karl Blanchard]

Only have one mag unfortunetely.  I put about 200 through it today.  I am gonna strip it down and clean it again and then take it out tomorrow and shoot it some more so we will see

[high country]

It's junk. I will buy it to ease your pain.

[Sportfury]

I have had issues with a TC .22 rifle that I have. If I do not have the ammo pushed fully back in the clip then it would jam. When it shoots it shoots great, but it is finicky with how the ammo sits in the clip.

[waterdoctor]

I have had the same problem with two High-Standard pistols. It was the mag.  A lot of the after market mags just are not that good. 

[Arnbo]

Remington Golden Ammo is crap!It has gone downhill.My 10/22 will cycle anything ,But our 597 does not like it.With or without the stock magazine.The Remington 30 round magazines are total Crap.

[high country]

I would snug the feed lips up a bit on the mag.

[JackOfAllTrades]

I would snug the feed lips up a bit on the mag.

Happens on the first round or last round?  The mag spring is new I suspect. Probably just too much tention but the lips should hold it at less angle when the slide is stripping the round from the mag follower. Also, much of that High Velocity ammo is 40-42gn lead bullets. Most Standard Velocity is 32-36gn. The heavier bullets make the cartridge some .990" where-as the lighter bullets make the cartridge much shorter at .960".  This is enough to create feed problems in some guns. Those High Standards are target pistols, designed for target or at least Standard Velocity cartridges.  Try some standard velocity in it before you modify the mag lips. Otherwise High Standard is http://highstandard.com  and I'm told they have good customer service.
 
-Steve

[Kc_Kracker]

did you by chance field strip it and put it back wrong?