HELP!!!!!!!

[Buck_Nasty11]

i am no machanic by any means, and i am in a pickle!  i leave tomorrow evening for my wyoming hunt, i changed out my front brakes and something is not right!!! i took my truck around the block and it feels like the brake is on consistantly! i pull back into my driveway and i have smoke coming off of my front right side! new pads and rotors are what i installed. what can it be??

[Russ McDonald]

i am no machanic by any means, and i am in a pickle!  i leave tomorrow evening for my wyoming hunt, i changed out my front brakes and something is not right!!! i took my truck around the block and it feels like the brake is on consistantly! i pull back into my driveway and i have smoke coming off of my front right side! new pads and rotors are what i installed. what can it be??

Did you bleed your breaks?  I would do that and then see what it does.

[sled]

What is your location?

[Buck_Nasty11]

No I haven't. I'm kinda thinking to buy a new caliper for that side and try to figure out how to bleed them


Sent from my iPhone using Tapatalk

[Buck_Nasty11]

Lake tapps


Sent from my iPhone using Tapatalk

[Tbar]

There should be a bleeder valve on top of the calipers.  That may solve your issue.

[TheHunt]

Your caliper is stuck and you can fix it if it needs bleeding.

Worse case is the pistons on the caliper are rusted.  If they worked perfectly before the pad change.  You have air in your line is my bet. 

[Buck_Nasty11]

Your caliper is stuck and you can fix it if it needs bleeding.

Worse case is the pistons on the caliper are rusted.  If they worked perfectly before the pad change.  You have air in your line is my bet.

so i should try bleeding the brake lines before purchasing a new caliper? the pistons on the caliper looked pretty tore up..

[TheHunt]

If the pistons are messed up buy the caliper and be done with it...

[dewandgin]

Caliper is stuck buy a new one and be done with it.

From the Wetside. like the darkside only Wetter!

[Buck_Nasty11]

If the pistons are messed up buy the caliper and be done with it...

ill need to bleed it if i get the new caliper right??

[dewandgin]

Yes just put the new Caliper on and make sure the bleeder screw is facing up answer then open the bleeder and without pumping the brakes let it run out. After a couple of minutes of this then tighten bleeder  screw and have someone get in and have them lightly push on the brake pedal,open up the bleeder and have them push it to the floor and hold it. Close bleeder and release. Should be all done and good firm brake pedal 

From the Wetside. like the darkside only Wetter!

[TheHunt]

Before you start...

take the break fluid container off and put a plastic lunch bag or something like it and put the cap back on it. This will hold a vacuum with the break fluid while you take the line off the caliper.   

[Johnb317]

I'm sure if you look there are lots of videos that show how to bleed your brakes.
Dbl check your job, and flush in new fluid.  Should do that every3-5 years anyway. 

Good luck

[Buck_Nasty11]

thanks guys i apperciate it!!