Control Board Solder Points for w80

[septemberfan]

I have been following the homebrew trailcam and I am testing out the camera I built. While I was on Yeticam's website I read about soldering some points on the back of my control board. I didn't solder any and the camera seems to work fine. I got 176 photos of some masked bandits raiding my deer feed pile. I was just wondering if I am suppose to solder any of the terminals on the back of the control board?

[gkowen]

Mine came with them already soldered when I ordered a control board for the W80. So if you ordered that you are ok. If it works, use it. Have fun

[BobR]

Septemberfan, The jumper pads on the boards come already soldered. Nice job on the camera. Thanks for posting.
Bob

[septemberfan]

Thanks for the clarification. Now I just need to get the deer to come in instead of the raccoons! 

[BobR]

  Get a trace mineral block, and the deer and elk will come.
Bob

[septemberfan]

Right behind the raccoon is a trace mineral block.  I have watched several deer walk up and smell it then walk away.  I have never seen one lick it.  I have had it there almost a month. I recently began the deer feed so hopefully I will get some that way.  Of course blacktails seem to ignore most stuff I have tried.

[BobR]

  I get three to five hundred pics a day at a mineral lick, but those licks have been
there for many years.
Bob