collapse

Advertisement


Author Topic: Need an outboard mechanic  (Read 3914 times)

Offline CP

  • Trade Count: (+6)
  • Old Salt
  • ******
  • Join Date: Mar 2008
  • Posts: 7245
  • Location: Mukilteo
Need an outboard mechanic
« on: July 09, 2017, 03:42:00 PM »
My Suzuki DF70 needs some TLC - anyone know a good mechanic in the Everett area?


Offline CP

  • Trade Count: (+6)
  • Old Salt
  • ******
  • Join Date: Mar 2008
  • Posts: 7245
  • Location: Mukilteo
Re: Need an outboard mechanic
« Reply #1 on: July 10, 2017, 07:40:20 AM »
Anyone ?

Offline lokidog

  • Trade Count: (+6)
  • Explorer
  • ******
  • Join Date: Mar 2009
  • Posts: 15186
  • Location: Sultan/Wisconsin
Re: Need an outboard mechanic
« Reply #2 on: July 10, 2017, 08:13:51 AM »
I use Tom n Jerrys in Anacortes but don't know if they work on Suzuki.  One of my neighbors uses the place in Mount Vernon next to I-5, they sell Suzukis.

Is it carbureted or fuel injected? What is the problem?  If carbureted, it is often not too hard to remove and clean them out. I just did this on a 1996 Honda 50 for my parents, the jets were blocked from leaving fuel in it for two years w/o running it.

Offline Henrydog

  • Trade Count: (0)
  • Sourdough
  • *****
  • Join Date: Feb 2016
  • Posts: 1125
  • Location: Eastern Washington
  • Groups: NRA Life Member, RMEF, Phesants Forever
Re: Need an outboard mechanic
« Reply #3 on: July 10, 2017, 08:27:11 AM »
I'm a marine adjuster, the only shop around that does Suzie's in WA is Performance Marine in Everett, Spokane Valley Marine, and I believe Valley Sports in Renton. 

Offline CP

  • Trade Count: (+6)
  • Old Salt
  • ******
  • Join Date: Mar 2008
  • Posts: 7245
  • Location: Mukilteo
Re: Need an outboard mechanic
« Reply #4 on: July 10, 2017, 08:28:15 AM »
Its fuel injected.  It runs fine until the throttle is advanced beyond half way, then it starts missing and sometimes dies.  Like it runs out of gas.  Pull the throttle back or restart and it goes back to running fine.  Been through the usual suspects, tried different gas tanks, fuel lines, and changed the injectors, made sure it has fresh gas free of water …

Maybe it’s the one of the fuel pumps, or some sensor.  I don’t have the equipment to read the fault codes.

I’ll give Performance Marine a call when they open.  If they can’t take it I’ll try the place in Mount Vernon.

Thanks for the tips.

Offline CP

  • Trade Count: (+6)
  • Old Salt
  • ******
  • Join Date: Mar 2008
  • Posts: 7245
  • Location: Mukilteo
Re: Need an outboard mechanic
« Reply #5 on: July 10, 2017, 08:46:36 AM »
2 to 3 weeks wait time.   :bash:

Offline lokidog

  • Trade Count: (+6)
  • Explorer
  • ******
  • Join Date: Mar 2009
  • Posts: 15186
  • Location: Sultan/Wisconsin
Re: Need an outboard mechanic
« Reply #6 on: July 10, 2017, 08:53:41 AM »
Good luck.  Sorry I can't help with fuel injection issues.  I've been thinking of trying to find some kind of training classes for outboard repair.

Offline CP

  • Trade Count: (+6)
  • Old Salt
  • ******
  • Join Date: Mar 2008
  • Posts: 7245
  • Location: Mukilteo
Re: Need an outboard mechanic
« Reply #7 on: July 10, 2017, 11:51:38 AM »
Called everyone within 100 miles.  Same story, 2 to 3 week wait or worse.  Looks like I'm fixing this myself or missing Chinook season.

or I'm putting around at half throttle. 

Offline gaddy

  • Non-Hunting Topics
  • Trade Count: (0)
  • Frontiersman
  • *****
  • Join Date: Sep 2010
  • Posts: 2920
Re: Need an outboard mechanic
« Reply #8 on: July 10, 2017, 02:17:25 PM »
Similar problem on my 25 once. Ended up being the diaphragm on the carburetor was week and couldn't keep up with the higher rpm's. Mine has 4 screws holding the cover. Might be an easy fix for you or you at least eliminate that scenario.

Offline CP

  • Trade Count: (+6)
  • Old Salt
  • ******
  • Join Date: Mar 2008
  • Posts: 7245
  • Location: Mukilteo
Re: Need an outboard mechanic
« Reply #9 on: July 10, 2017, 03:37:34 PM »
I found a partly pinched fuel line to the low pressure fuel pump.  Hopefully that's the problem.  I rerouted that line and checked the pump.  All looks well. 

I need a sea trial to tell for sure.  It always ran fine on the hose.


Offline gaddy

  • Non-Hunting Topics
  • Trade Count: (0)
  • Frontiersman
  • *****
  • Join Date: Sep 2010
  • Posts: 2920
Re: Need an outboard mechanic
« Reply #10 on: July 10, 2017, 04:03:26 PM »
good luck !

Offline CP

  • Trade Count: (+6)
  • Old Salt
  • ******
  • Join Date: Mar 2008
  • Posts: 7245
  • Location: Mukilteo
Re: Need an outboard mechanic
« Reply #11 on: July 11, 2017, 06:24:09 AM »
Well that fixed it.  Mostly anyway, still a bit of a high speed miss.  At least now it gets to high speed.  I'll change all the fuel lines, they are pretty soft.  I think I just saved myself a few hundred $$$


Offline lokidog

  • Trade Count: (+6)
  • Explorer
  • ******
  • Join Date: Mar 2009
  • Posts: 15186
  • Location: Sultan/Wisconsin
Re: Need an outboard mechanic
« Reply #12 on: July 11, 2017, 07:48:21 AM »
Well that fixed it.  Mostly anyway, still a bit of a high speed miss.  At least now it gets to high speed.  I'll change all the fuel lines, they are pretty soft.  I think I just saved myself a few hundred $$$

 :tup: :tup:

I've had even the newer ethanol safe fuel lines go bad after a while.

Offline Wazntme

  • Trade Count: (0)
  • Hunter
  • ***
  • Join Date: Oct 2013
  • Posts: 123
  • Location: Wa
  • Groups: NRA
Re: Need an outboard mechanic
« Reply #13 on: July 14, 2017, 05:48:10 AM »
I had fuel management issues a couple months ago and I took it to Camino marine up just past stanwood and they did a fast honest job and havnt had any problems since

 


* Advertisement

* Recent Topics

Idaho deer question by huntnnw
[Yesterday at 11:08:25 PM]


good area for idaho elk open to public by pd
[Yesterday at 10:29:47 PM]


Who knows electric bikes? looking at Quietkat options by Westside88
[Yesterday at 09:00:34 PM]


GO 2025 15th Annual Hunting-Washington Christmas Gift Exchange by ASHQUACK
[Yesterday at 08:55:35 PM]


Blackstone newbie by kenzmad
[Yesterday at 08:48:46 PM]


Anyone own a Hewescraft Sportsman 160? by Crunchy
[Yesterday at 08:23:33 PM]


Idaho on the verge of outlawing by HUNTINCOUPLE
[Yesterday at 08:03:41 PM]


Tease 'l' by highcountry_hunter
[Yesterday at 07:43:59 PM]


Quality deer hunt by Rainier10
[Yesterday at 07:36:09 PM]


Ice fishing for walleye by Russ McDonald
[Yesterday at 07:05:13 PM]


Put a ring on it by trophyhunt
[Yesterday at 05:20:59 PM]


Hunting DNR Natural Area Preserves by 509
[Yesterday at 05:18:11 PM]


Pointing Dog Trainer by wildweeds
[Yesterday at 04:52:56 PM]


Homemade saltwater fishing gear by Wetwoodshunter
[Yesterday at 04:32:08 PM]


Montana Cutting Deer Licenses by JWBINX
[Yesterday at 02:55:36 PM]


The Lookback by bearhunter99
[Yesterday at 01:06:08 PM]


This year, last year by Caseknife
[Yesterday at 12:58:10 PM]


Stickers by boneaddict
[Yesterday at 12:16:11 PM]


From Behind by boneaddict
[Yesterday at 11:48:13 AM]


Kubota repair shop by Happy Gilmore
[Yesterday at 10:40:20 AM]

SimplePortal 2.3.7 © 2008-2025, SimplePortal