Hunting with a muzzy for the first time

[jasnt]

Me and my girlfriend will be hunting with a tc hawken for elk this year for our first time. What are some things we should know about hunting with a muzzy.  Season starts October 1-7th. Forecast shows some rain and prob several wet days ahead.  How do you keep things dry and protect the nipple and cap from moisture?

Any tips/ advice is appreciated!
We are using the load shot by the previous owner
110 gr of ffg goex and precision rifles QT 235gr/.50 cal or precision rifle Dead Center 240 gr
RWS no 1075 plus caps

[Blacktail Sniper]

For my old school Hawken, I took a bike innertube and cut it into small rectangles.  Folded them in half, then placed over the nipple hole and lowered hammer the to hold them in place. 

They have to be bigger than the hammer and folded, so when you cock it, they pop off.

Small piece of tape over the muzzle end, gas pressure will pop it off when you fire.

[solomtnhunter]

Hypothetically speaking  One could say placing small piece of electrical tape over it works great because if in case "someone" shows up you can quickly just peel it off before inspection.

[JimmyHoffa]

I put tape or a piece of plastic bag over the end of the barrel.  And have a piece of rawhide that would go between the hammer and nipple.  When you cock the hammer the rawhide falls away and you're ready for a cap.

[ghosthunter]

Take what you need to break it down and clean it to camp. If it rains I would empty and fresh load each day.
For me I take a gun vise to camp.

[jasnt]

Take what you need to break it down and clean it to camp. If it rains I would empty and fresh load each day.
For me I take a gun vise to camp.

that brings up another question.  What do I need to un load these sabot's

[Hunter15]

A cap and powder

[Smoke]

moisture... tape over the muzzle works, but if damp the tape wont stick... I use a small balloon, or a condom... the bullet will pass right thru it without affecting aim.. as for the nipple, with no cap installed, the rubber works fine, leather can attract moisture so I'd stay clear of that.. once in the woods and you install your cap, vaseline works great, just rub some on the OUTSIDE of the cap and nipple to seal it... make sure not to get any inside the cap... it can cause a misfire (dud)
unloading...  just fire into a tree or the ground... or if you want the rich peoples way, there are CO2 kits that attach at the nipple and push the charge out with compressed gas... a lot of the newer rifles come with a removable breach plug, if thats the case you can remove the breach and using your ram rod push it out....

good luck

[jasnt]

Thanks for the reply's.  Shooting an old tc hawken so no breach plug. 

[Goex2Fwithroundball]

I have been hunting with my TC Hawken .54 for many years in all weather. I used to worry when I hunted in the rain. During heavy rain I just cover the hammer and cap with my hand. Be sure to pinch the cap a little before you put it on the nipple to ensure a snug fit.
At the end of each day of hunting I always shoot and swab. Then start the next day with  a fresh charge. Even after hunting in heavy rain all day my Hawken has always fired.
Good luck.

[JimmyHoffa]

When I would fire at night/clean/reload in the morning--right before reloading, I would have just a cap and put the muzzle near a leaf or paper and then fire.  Did this to make sure it went poof and make sure the gas from the cap made it into the barrel. 

[Romeo 2-6]

I use soft beeswax (toilet sealing ring from the hardware store is cheap) to smear around the cap on the nipple. Keep a little Ina Baggie in your pocket for when you re-cap. Keeps moisture outta the cap.


Sent from my iPhone using Tapatalk

[MD36]

Or you could just carry the rifle upside down when raining mine always ignites.

[crowinghen]

unloading...  just fire into a tree or the ground... or if you want the rich peoples way, there are CO2 kits that attach at the nipple and push the charge out with compressed gas... a lot of the newer rifles come with a removable breach plug, if thats the case you can remove the breach and using your ram rod push it out....

good luck

I am able to remove the breech plug on my gun. I was wondering if it's okay to use the bullet and sabot? Obviously if not shot.
Thanks!

[jasnt]

Thanks for all the info! I don't know how I'll sleep tonight.