collapse

Advertisement


Author Topic: Need an outboard mechanic  (Read 3881 times)

Online CP

  • Trade Count: (+6)
  • Old Salt
  • ******
  • Join Date: Mar 2008
  • Posts: 7223
  • Location: Mukilteo
Need an outboard mechanic
« on: July 09, 2017, 03:42:00 PM »
My Suzuki DF70 needs some TLC - anyone know a good mechanic in the Everett area?


Online CP

  • Trade Count: (+6)
  • Old Salt
  • ******
  • Join Date: Mar 2008
  • Posts: 7223
  • Location: Mukilteo
Re: Need an outboard mechanic
« Reply #1 on: July 10, 2017, 07:40:20 AM »
Anyone ?

Offline lokidog

  • Trade Count: (+6)
  • Explorer
  • ******
  • Join Date: Mar 2009
  • Posts: 15186
  • Location: Sultan/Wisconsin
Re: Need an outboard mechanic
« Reply #2 on: July 10, 2017, 08:13:51 AM »
I use Tom n Jerrys in Anacortes but don't know if they work on Suzuki.  One of my neighbors uses the place in Mount Vernon next to I-5, they sell Suzukis.

Is it carbureted or fuel injected? What is the problem?  If carbureted, it is often not too hard to remove and clean them out. I just did this on a 1996 Honda 50 for my parents, the jets were blocked from leaving fuel in it for two years w/o running it.

Offline Henrydog

  • Trade Count: (0)
  • Sourdough
  • *****
  • Join Date: Feb 2016
  • Posts: 1124
  • Location: Eastern Washington
  • Groups: NRA Life Member, RMEF, Phesants Forever
Re: Need an outboard mechanic
« Reply #3 on: July 10, 2017, 08:27:11 AM »
I'm a marine adjuster, the only shop around that does Suzie's in WA is Performance Marine in Everett, Spokane Valley Marine, and I believe Valley Sports in Renton. 

Online CP

  • Trade Count: (+6)
  • Old Salt
  • ******
  • Join Date: Mar 2008
  • Posts: 7223
  • Location: Mukilteo
Re: Need an outboard mechanic
« Reply #4 on: July 10, 2017, 08:28:15 AM »
Its fuel injected.  It runs fine until the throttle is advanced beyond half way, then it starts missing and sometimes dies.  Like it runs out of gas.  Pull the throttle back or restart and it goes back to running fine.  Been through the usual suspects, tried different gas tanks, fuel lines, and changed the injectors, made sure it has fresh gas free of water …

Maybe it’s the one of the fuel pumps, or some sensor.  I don’t have the equipment to read the fault codes.

I’ll give Performance Marine a call when they open.  If they can’t take it I’ll try the place in Mount Vernon.

Thanks for the tips.

Online CP

  • Trade Count: (+6)
  • Old Salt
  • ******
  • Join Date: Mar 2008
  • Posts: 7223
  • Location: Mukilteo
Re: Need an outboard mechanic
« Reply #5 on: July 10, 2017, 08:46:36 AM »
2 to 3 weeks wait time.   :bash:

Offline lokidog

  • Trade Count: (+6)
  • Explorer
  • ******
  • Join Date: Mar 2009
  • Posts: 15186
  • Location: Sultan/Wisconsin
Re: Need an outboard mechanic
« Reply #6 on: July 10, 2017, 08:53:41 AM »
Good luck.  Sorry I can't help with fuel injection issues.  I've been thinking of trying to find some kind of training classes for outboard repair.

Online CP

  • Trade Count: (+6)
  • Old Salt
  • ******
  • Join Date: Mar 2008
  • Posts: 7223
  • Location: Mukilteo
Re: Need an outboard mechanic
« Reply #7 on: July 10, 2017, 11:51:38 AM »
Called everyone within 100 miles.  Same story, 2 to 3 week wait or worse.  Looks like I'm fixing this myself or missing Chinook season.

or I'm putting around at half throttle. 

Offline gaddy

  • Non-Hunting Topics
  • Trade Count: (0)
  • Frontiersman
  • *****
  • Join Date: Sep 2010
  • Posts: 2920
Re: Need an outboard mechanic
« Reply #8 on: July 10, 2017, 02:17:25 PM »
Similar problem on my 25 once. Ended up being the diaphragm on the carburetor was week and couldn't keep up with the higher rpm's. Mine has 4 screws holding the cover. Might be an easy fix for you or you at least eliminate that scenario.

Online CP

  • Trade Count: (+6)
  • Old Salt
  • ******
  • Join Date: Mar 2008
  • Posts: 7223
  • Location: Mukilteo
Re: Need an outboard mechanic
« Reply #9 on: July 10, 2017, 03:37:34 PM »
I found a partly pinched fuel line to the low pressure fuel pump.  Hopefully that's the problem.  I rerouted that line and checked the pump.  All looks well. 

I need a sea trial to tell for sure.  It always ran fine on the hose.


Offline gaddy

  • Non-Hunting Topics
  • Trade Count: (0)
  • Frontiersman
  • *****
  • Join Date: Sep 2010
  • Posts: 2920
Re: Need an outboard mechanic
« Reply #10 on: July 10, 2017, 04:03:26 PM »
good luck !

Online CP

  • Trade Count: (+6)
  • Old Salt
  • ******
  • Join Date: Mar 2008
  • Posts: 7223
  • Location: Mukilteo
Re: Need an outboard mechanic
« Reply #11 on: July 11, 2017, 06:24:09 AM »
Well that fixed it.  Mostly anyway, still a bit of a high speed miss.  At least now it gets to high speed.  I'll change all the fuel lines, they are pretty soft.  I think I just saved myself a few hundred $$$


Offline lokidog

  • Trade Count: (+6)
  • Explorer
  • ******
  • Join Date: Mar 2009
  • Posts: 15186
  • Location: Sultan/Wisconsin
Re: Need an outboard mechanic
« Reply #12 on: July 11, 2017, 07:48:21 AM »
Well that fixed it.  Mostly anyway, still a bit of a high speed miss.  At least now it gets to high speed.  I'll change all the fuel lines, they are pretty soft.  I think I just saved myself a few hundred $$$

 :tup: :tup:

I've had even the newer ethanol safe fuel lines go bad after a while.

Offline Wazntme

  • Trade Count: (0)
  • Hunter
  • ***
  • Join Date: Oct 2013
  • Posts: 123
  • Location: Wa
  • Groups: NRA
Re: Need an outboard mechanic
« Reply #13 on: July 14, 2017, 05:48:10 AM »
I had fuel management issues a couple months ago and I took it to Camino marine up just past stanwood and they did a fast honest job and havnt had any problems since

 


* Advertisement

* Recent Topics

2025 OILS! by SkookumHntr
[Today at 01:01:21 PM]


Homemade saltwater fishing gear by metlhead
[Today at 12:55:55 PM]


New world record mule? by EnglishSetter
[Today at 12:29:32 PM]


Any MT deer updates? by Craig
[Today at 11:12:27 AM]


Question about hunting wilderness areas by EnglishSetter
[Today at 11:07:38 AM]


GM 6.6l gas 6 speed vs. 10 speed? by Happy Gilmore
[Today at 10:44:31 AM]


Spotting scope mounting plate by Crunchy
[Today at 10:38:16 AM]


5 Points......(mule deer or blacktails) by raydog
[Today at 10:18:03 AM]


Real world feedback needed: Rangefinder Binos by carpsniperg2
[Today at 10:09:28 AM]


2025 Quality Chewuch Tag by boneaddict
[Today at 10:05:39 AM]


I can only take duck at a time! by pianoman9701
[Today at 09:40:15 AM]


2025 deer, let's see em! by mountainman
[Today at 09:21:17 AM]


Cougar license question by Blacktail Sniper
[Today at 08:59:24 AM]


2024 Ford Edge Opinion/Bought a Chevrolet by C-Money
[Today at 08:47:16 AM]


Drew Pogue Quality by HikerHunter
[Today at 08:36:39 AM]


Aladdin unit 111 mule deer quality tag by tgomez
[Today at 12:49:11 AM]


Where can one find hides from hunters? by paninilord
[Yesterday at 09:12:37 PM]


Older SxS shotgun by JDHasty
[Yesterday at 08:53:52 PM]


Bull moose...luck or ??? by MADMAX
[Yesterday at 08:46:37 PM]


What boots? by pickardjw
[Yesterday at 08:38:07 PM]

SimplePortal 2.3.7 © 2008-2025, SimplePortal